Handlebar switch Kawasaki Z 750 B right OEM Replica

OEM reproduction right side handlebar switch assembly suitable for several Kawasaki models KZ: compatible with standard handlebars diameter 22mm. OEM part number Kawasaki: 46091-1047, 46132-024. Complete with 50cm wiring included (measured to the end of the shortest wire): 1 squared connector with 4 wires, 1 wire with pin connector and 1 wire with flat connector. This is for use with a double-cable desmo throttle control push pull set up (you can just run a pull cable if you want).

Functions:

• ignition with push button start
• engine kill with 2 static positions off
• lights 2 static positions on/off

Tip: check your wiring harness and make sure the connectors will work. It's common for the starter button's on these bikes to wear out due to arcing or they can break for various reasons: corrosion and cracked solder joints on the stock switch make for an unreliable and unsafe switch. This is an easy part to replace if your wires aren't running through the handlebars, if they are, it requires removing the handlebars and feeding the wires through. If you use an aftermarket handlebar please make sure that wire harness is long enough.